The Mid-mastview system shows the driver on the monitor the view along the fork after the freelift stage. This allows correct positioning. Also, this configuration provides a view on the racking when non-Euro pallets are used With a Mid-mastview system the camera is mounted (mostly on an additional bracket) on the cross member of the inner mast stage. The sturdy monitor comes with a fully adjustable clamp bracket that is mounted on the reach truck’s guardrail.
On the monitor the Forkview system shows the operator the view along the fork. This allows correct positioning of the fork. Shoulder- and neck muscles need not be strained anymore. Also correct positioning of loads reduces damages. The Forkview system has a camera mounted at the inside of the right-hand side fork. The sturdy monitor comes with a fully adjustable clamp bracket that is mounted on the reach trucks guardrail.
Drilling holes in the fork is only allowed with formal permission of the fork manufacturer. To mount the camera with M6 bolts, holes of 11mm deep are drilled, resulting in 9mm effective thread. This is 1.5 times the length of a M6 bolt and is sufficient to hold the M6 bolt. Orlaco can not be held responsible for any damage to the forks or damage resulting from malfunctioning forks.
The View-on-forks system allows the driver to see on the monitor an optimal view along the fork. This allows correct positioning, without making the fork wider. With the View-on-forks system, the camera is mounted under the fork carriage. The sturdy monitor comes with a fully adjustable clamp bracket that is mounted on the reach trucks guardrail.